CH-T // ACTIVE TELEMETRY
24.6°C
TARGET 22.0°C · SENSOR OK · LINK SIMULATED
CH-1–4 // OUTPUT RELAYS
PUMP
ON
FAN
ON
HEATER
OFF
SPARE
OFF
SYS // EVENT LOG — DEMO MODE
[00:00:00] Simulator initialised — no physical relays connected
[00:00:01] Scenario: Normal operation · Target 22.0°C
[00:00:02] CH1 PUMP → ON · CH2 FAN → ON
[00:00:03] Temperature 24.6°C · Sensor status OK · Controller online
DEMO ONLY · NO PHYSICAL RELAYS CONNECTED
Controller IO
RELAY CHANNELS
TARGET TEMPERATURE
Simulated state only. Outputs update the browser demo and are never sent to hardware, MQTT, or cloud services.
24.0 °C
● CH1 PUMP
○ CH2 FAN
○ CH3 HEATER
○ CH4 SPARE
// SCENARIO SELECTION CONSOLE
Simulated Scenarios
Inject predefined environmental conditions, sensor faults and offline states into the browser-only demo controller. No physical relays or live data are affected.
⚠ ERR-S01
SENSOR FAULT
Override the temperature probe with an invalid reading to test fault detection and safe output fallback.
⊘ NET-00
OFFLINE STATE
Simulate a lost connection so the controller runs on local logic and reports an offline status.
▲ T-HIGH
HIGH HEAT
Raise the simulated temperature above target to verify fan and pump cooling response.
▼ T-LOW
EXTREME COLD
Drop the simulated temperature well below target to test heater activation and frost protection.
SIMULATION NOTICE
This Equipment Simulator is a browser-only test and demo interface for the ETS Climate Intelligence Platform four-channel Raspberry Pi controller. Pump, fan, heater, spare output, temperature readings, offline conditions, sensor faults, scenarios and target-temperature control are all simulated. No physical relays, MQTT brokers, Supabase credentials or customer data are connected. This is not a live production environment.